high visibility hooded unisex

• 9.5 oz./yd, 80/20 cotton/polyester
• Pre-shrunk
• 2" silver 3M, front and back, laminate striping
• Double-lined hood
• Matching drawstring
  
• Spandex in cuffs and bottom band
• Split pouch pocket

This item uses Bayside style 900

*Please call customer service for availability

• 9 oz./yd, 100% polyester fleece
• 5 oz./yd, thermal lining
• Double-layered three-piece hood
• Nylon front zipper
• Oversized front pockets
• Reinforced bartacks at stress points
• Double-needle stitched main seams

• Flame-resistant, 10.5 oz./yd (355 g/m), 67% Modacrylic/ 29% Cotton/ 4% Polyester
• 360 visibility with front and back 2" flame resistant heat seal silver reflective striping
• Hood with drawcord closure
• Rib knit cuff and waistband
• Large hand warmer pocket, concealed utility pocket inside front pocket
• IQ reinforcement at interior of sleeves

Tall sizes available under style SMH4T

• 8 oz./yd, polyester softshell bonded to micro fleece
• Water and wind resistant
• 2" reflective tape
• ANSI/ISEA 107-2015 Type R Class 3 Certified

• 100% polyester
• 4 layer filtration system provides basic protection against non-toxic dust, smoke and other non-toxic particles found on the job site
• Concealed reflective piping along hood, front and back chest seams for better low light visibility
• Thumbhole on cuffs
  
• Durable lightweight lime water-resistant ripstop shell with lining
• Adjustable hood
• 2 wide high-performance reflective tape
• Durable black water-resistant ripstop in high-wear areas, along the sides and under the arms
• Tall collar design with asymmetrical zipper to avoid chaffing
• Left chest pocket with a zipper closure
• Lower slash pockets with a zipper closure

• Polyester
• Durable waterproof seam sealed shell with thermal insulation
• 2 wide reflective material with 3 contrasting panels
• Detachable hood
• Black bottom front & sleeves
• Lower slash pockets angled
• Left chest radio pocket with flap and D-ring

ANSI/ISEA 107 2015 / ANSI/ISEA 107 2020 Type R Class 3

Fabric dye lot variances may occur and meet luminance factor as stated in the standard.